Usgs Bluebird House Plans Using One Board

Essential Aspects of USGS Bluebird House Plans Using One Board

The United States Geological Survey (USGS) offers free plans for building bluebird houses using a single board. These plans are designed to provide a safe and suitable nesting site for bluebirds and other cavity-nesting birds.

### Materials Required

To build a USGS bluebird house using one board, you will need the following materials:

- One 1x12-inch board, 12 feet long - Wood screws - Galvanized wire for the perch ### Cutting the Board

The first step is to cut the board into the following pieces:

- Two 12-inch pieces for the front and back - Two 10-inch pieces for the sides - One 6-inch piece for the roof - One 4-inch piece for the bottom ### Assembling the House

Once the pieces are cut, begin assembling the house by attaching the sides to the front and back pieces. Next, attach the roof to the top of the house. Finally, attach the bottom to the house, making sure that the entrance hole is at the bottom of the front piece.

### Adding the Perch

The last step is to add the perch. Drill a small hole in the front of the house, just below the entrance hole. Thread the wire through the hole and tie it off on the outside of the house. The perch should be about 3 inches below the entrance hole.

### Installing the House

Choose a location for your bluebird house that is in an open area with plenty of sunlight. Mount the house on a post or tree at a height of 5-8 feet.

### Additional Tips

Here are a few additional tips for building and installing a USGS bluebird house:

- Paint the house a light color to reflect the sun and keep it cool. - Do not use treated lumber, as the chemicals can be harmful to birds. - Clean out the house regularly to remove any debris or nesting material. - Monitor the house during the nesting season to ensure that it is being used by bluebirds.